Kontron AT8404 CLI - Manual (Page 79)

AT8404 Switching Commands
Page 2 - 43 AT8404 CLI Reference Manual
2.11.5 dot1x guest-vlan
This command configures VLAN as guest vlan on a per port basis. The command specifies an active VLAN as an
IEEE 802.1x guest VLAN. The range is 1 to the maximumVLAN ID supported by the platform.
2.11.5.1 no dot1x guest-vlan
This command disables Guest VLAN on the interface.
2.11.6 dot1x initialize
This command begins the initialization sequence on the specified port. This command is only valid if the control
mode for the specified port is 'auto'. If the control mode is not 'auto' or an error will be returned.
2.11.7 dot1x login
This command assigns the specified authentication login list to the specified user for 802.1x port security. The
<user> parameter must be a configured user and the <listname> parameter must be a configured authentication
login list.
2.11.8 dot1x max-req
This command sets the maximum number of times the authenticator state machine on this port will transmit an
EAPOL EAP Request/Identity frame before timing out the supplicant. The <count> value must be in the range 1 -
10.
Format dot1x default-login <listname>
Mode Global Config
Default disabled
Format dot1x guest-vlan <vlan-id>
Mode Interface Config
Default disabled
Format no dot1x guest-vlan
Mode Interface Config
Format dot1x initialize <slot/port>
Mode Privileged EXEC
Format dot1x login <user> <listname>
Mode Global Config
Default 2
Format dot1x max-req <count>
Mode Interface Config