8 set board clock override, 9 set board clock receiver, 10 set board clock source – Kontron AT8404 CLI User Manual
Page 326: 11 show boardinfo clock bpl, Set board clock override - 50, Set board clock receiver - 50, Management commands at8404
Management Commands
AT8404
AT8404 CLI Reference Manual
Page 5 - 50
<bplclk> = {clk1a|clk1b|clk2a|clk2b|clk3a|clk3b}
5.16.8
set board clock override
The command overrides the clock ekeying for an AMC clock. A correct MUX setting (set board clock mux-amc) must
be done before. If the source for an AMC clock is set to PLL, the clock frequence must be specified too, otherwise
the related parameter is not used.
<amc> = {amcb1|amcb2|amcb3|amcb4}
5.16.9
set board clock receiver
The command configures the clock description for clocks from the AMC. You can specify for family and accuracy
either default values (sonet/stratum3 or sonet/stratum3E) or any protocol value (0..255). You can specify for
frequency a well-known value or any other value (unit is Hz).
<amc> = {amcb1|amcb2|amcb3|amcb4}
5.16.10
set board clock source
The command configures the clock description for clocks to the AMC. You can specify for family and accuracy either
default values (sonet/stratum3 or sonet/stratum3E) or any protocol value (0..255). You can specify for frequency a
well-known value or any other value (unit is Hz).
<amc> = {amcb1|amcb2|amcb3|amcb4}
5.16.11
show boardinfo clock bpl
This command shows the configuration of backplane clocks. The backplane clocks are displayed with the state
(enabled/disabled) and (if enabled) the mapped AMC source with clock configuration attributes.
Mode
Priviledged EXEC
Format
set board clock override
<amc> {tclka|tclkc} {enable|disable}
[2kHz|8kHz|19_44MHz]
Mode
Priviledged EXEC
Format
set board clock receiver
<amc>
{
tclkb|tclkd}
enable sonet
{stratum3|stratum3E}
{8kHz|1_544MHz|2_048_MHz|19_44MHz}
set board clock receiver
<amc> {tclkb|tclkd}
enable
<family> <accuracy>
<frequency>
set board clock receiver
<amc> {tclkb|tclkd}
disabl
e
Mode
Priviledged EXEC
Format
set board clock source <amc> {tclka|tclkc} enable sonet
{stratum3|stratum3E} {8kHz|1_544MHz|2_048_MHz|19_44MHz}
set board clock source <amc> {tclka|tclkc} enable <family> <accuracy>
{8kHz|1_544MHz|2_048_MHz|19_44MHz}
set board clock source <amc> {tclka|tclkc} disable
Mode
Priviledged EXEC
Format
show boardinfo clock bpl
Mode
Priviledged EXEC