Kontron AT8404 CLI - Manual (Page 186)

Quality of Service (QoS) Commands AT8404
AT8404 CLI Reference Manual Page 3 - 12
3.3.5.1 no match class-map
This command removes from the specified class definition the set of match conditions defined for another class. The
<refclassname> is the name of an existing DiffServ class whose match conditions are being referenced by the
specified class definition.
3.3.6 match cos
This command adds to the specified class definition a match condition for the Class of Service value (the only tag
in a single tagged packet or the first or outer 802.1Q tag of a double VLAN tagged packet). The value may be from
0 to 7.
3.3.7 match secondary-cos
This command adds to the specified class definition a match condition for the secondary Class of Service value (the
inner 802.1Q tag of a double VLAN tagged packet). The value may be from 0 to 7..
3.3.8 match destination-address mac
This command adds to the specified class definition a match condition based on the destination MAC address of a
packet. The <macaddr> parameter is any layer 2 MAC address formatted as six, two-digit hexadecimal numbers
separated by colons (e.g., 00:11:22:dd:ee:ff). The <macmask> parameter is a layer 2 MAC address bit mask, which
Format no match class-map <refclassname>
Mode Class-Map Config
Ipv6-Class-Map Config
Note: This command is not available on the Broadcom 5630x platform.
Default none
Format match cos <0-7>
Mode Class-Map Config
Ipv6-Class-Map Config
Note: This command is supported on the following platforms:
• BCM56314
• BCM56504
• BCM56214
• BCM56224
Default none
Format match secondary-cos <0-7>
Mode Class-Map Config