Kontron NSN2U IP Network Server - Manual (Page 11)

10
Table 1NSN2U Server Features
Peripheral
Interfaces
External connections:
DB-15 video connector (rear)
RJ45 serial Port connector (one front and one rear)
Two RJ45 10/100/1000 Mbps network connections (rear)
Four USB 2.0 connectors (rear)
One USB 2.0 connector (front)
Internal connections:
Two low-profile USB 2x5-pin headers for low-profile
USB solid state drives, including the Smart Modular Z-
U130 Value Solid State Drive. One header is located on
the front panel board and the other header is on the
baseboard.
One DH-10 serial Port B header
Six Serial ATA (SATA) II connectors
Two I/O module connectors
One General Communications Module 4 (GCM4) connector
to enable optional Intel® Remote Management Module 3
functionality
Video
On-board ServerEngines* LLC Pilot II Controller
Integrated 2D Video Controller
32 MB DDR2 Memory
LAN Two 10/100/1000 Mbps Intel
®
82575 PHYs
Expansion
Capabilities
Riser card options:
Three full-height PCI Express* slots (passive)
Five-slot PCI-X riser:
Two full-height PCI-X slots with on-board PCI
Express to PCI-X bridge chips
One full-height PCI Express slot and two low-profile
PCI Express slots
Five-slot PCI Express riser:
Three full-height PCI Express slots and two low-
profile PCI Express slots
Hard Drive Options
Up to eight 2.5-inch SAS or SATA hard drives
1) SAS/SATA hardware RAID module
or
2) SAS/SATA control module
Peripherals
Slimline bay for one slimline SATA optical drive
PCI riser card assembly bracket
Front Panel
Buttons
Power on/off
System reset
Chassis ID