Kontron NSN2U IP Network Server - Manual (Page 42)

41
4. With the drive carrier locking lever fully open, push the hard drive carrier into
the drive bay in the chassis until it stops. (Figure 28, “A”)
5. Press the locking lever until it snaps shut and secures the drive in the bay.
6. Replace the front bezel. For instructions, see “Re-Installing the Front Bezel“ in
Section 3.2.
Figure 28. Inserting a New Hard Drive into the Chassis
4.3 Installing a SAS/SATA Control Module
Hard disk drives are not supported on the NSN2U server by default. One of two
separately-orderable controller options is required. The SAS/SATA control module is
the solution for basic SAS/SATA drive support. If you need hardware RAID support,
however, please see Section 4.4, “Installing a Hardware RAID Module“.
Figure 29 shows the SAS/SATA control module, which adds SAS/SATA support for the
server. The module’s interface to the baseboard for integrated software RAID 0/1/10
capability is through a PCI Express bus flex cable (“A”) to the bridge board. The
SAS/SATA control module is located in the front left of the chassis between the power
supply system and the SAS/SATA backplane board. The module’s gold edge connector (“C”)
mates with the SAS/SATA backplane board.
Figure 29. SAS/SATA Control Module