Driving and parking, Driving systems – Mercedes-Benz S-Coupe 2015 User Manual

Page 210

Advertising
background image

R

if the camera lenses are dirty or covered.

Observe the notes on cleaning

(

Y

page 330)

R

if the vehicle components in which the

cameras are installed are damaged. In this

event, have the camera position and setting

checked at a qualified specialist workshop.

Do not use the 360° camera in this case. You

can otherwise injure others or cause damage

to objects or the vehicle.
The guide lines in the COMAND display show

the distances to your vehicle. The distances

only apply to road level.

i

The camera in the rear area is protected

from raindrops and dust by means of a flap.

This flap opens when the 360° camera is

activated.
The flap closes again when:

R

you have finished the maneuvering proc-

ess

R

you switch off the engine

R

you open the trunk

Observe the notes on cleaning

(

Y

page 330).

For technical reasons, the flap may remain

open briefly after the 360° camera has

been deactivated.

Activation conditions

The 360° camera image can be displayed if:

R

COMAND is switched on (see the separate

operating instructions)

R

The

360° Camera

360° Camera

function is switched on.

i

If the 360° camera is activated at speeds

above approximately 19 mph (30 km/h), a

warning message appears.
The warning message disappears if:

R

the vehicle's speed falls below approx-

imately 19 mph (30 km/h). The 360°

camera is then activated.

R

the message is confirmed with the %

button.

Switching the 360° camera on and off

using the button

X

To switch on: press button :.

Depending on whether position D or R is

engaged, the following is shown:

R

full screen display with the image from

the front camera

R

full screen display with the image from

the rear view camera

X

To deactivate: press button : again.

i

You can also switch to the split-screen

view from the full-screen view.

Activating the 360° camera with

COMAND

X

Press the Ø button in the center con-

sole.

The vehicle menu is displayed.

X

To select the 360° camera: turn and press

the controller.

Depending on whether position D or R is

engaged, the following is shown:

R

a split screen with top view and the

image from the front camera or

R

a split screen with top view and the

image from the rear view camera

Further information on the COMAND control-

ler can be found in the separate operating

instructions.

208

Driving systems

Driving

and

parking

Advertising