Mercedes-Benz S-Coupe 2015 - Manual (Page 351)

If the automatic transmission cannot be shif-
ted to position N, have the vehicle transpor-
ted on a transporter or trailer.
The battery must be connected and charged.
Otherwise, you:
R cannot turn the SmartKey to position 2 in
the ignition lock
R
cannot release the electric parking brake
R cannot shift the automatic transmission to
position N
i Deactivate the automatic locking feature
(
Y
page 86). You could otherwise be locked
out when pushing or towing the vehicle.
Installing/removing the towing eye
Installing the towing eye
The brackets for the screw-in towing eyes are
located in the bumpers. They are at the front
and at the rear under covers :.
X
Remove the towing eye from the vehicle
tool kit/stowage tray (
Y
page 336).
X
Press the mark on cover : inwards in the
direction of the arrow.
X
Remove cover : from the opening.
X
Screw in and tighten the towing eye clock-
wise to the stop.
Removing the towing eye
X
Unscrew and remove the towing eye.
X
Attach cover : to the bumper and press
until it engages.
X Place the towing eye in the vehicle tool kit/
stowage tray.
Towing a vehicle with both axles on
the ground
It is important that you observe the safety
instructions when towing away your vehicle
(
Y
page 348).
The automatic transmission automatically
shifts to position P when you open the driver's
or front-passenger door or when you remove
the SmartKey from the ignition lock.
In order to ensure that the automatic trans-
mission stays in position N when towing the
vehicle, you must observe the following
points:
X You must use the SmartKey instead of the
Start/Stop button (
Y
page 147).
X
Make sure that the vehicle is stationary and
the SmartKey in the ignition lock is in posi-
tion 0.
X Turn the SmartKey to position 2 in the igni-
tion lock.
X
Depress and hold the brake pedal.
X
Shift the automatic transmission to posi-
tion N.
X Release the brake pedal.
X
Release the electric parking brake.
X
Leave the SmartKey in position 2 in the
ignition lock.
X Switch on the hazard warning lamps
(
Y
page 122).
i In order to signal a change of direction
when towing the vehicle with the hazard
warning lamps switched on, use the com-
bination switch as usual. In this case, only
the indicator lamps for the direction of
travel flash. After resetting the combina-
Towing and tow-starting
349
Roadside
Assistance
Z