Dr ivi ng an d parki ng, Driving systems – Mercedes-Benz S-Coupe 2015 User Manual

Page 220

Advertising
background image

As a result, Active Blind Spot Assist may nei-

ther give warnings nor intervene in such sit-

uations. There is a risk of an accident.
Always observe the traffic conditions care-

fully, and maintain a safe lateral distance.

i

USA only: This device has been approved

by the FCC as a "Vehicular Radar System".

The radar sensor is intended for use in an

automotive radar system only. Removal,

tampering, or altering of the device will void

any warranties, and is not permitted by the

FCC. Do not tamper with, alter, or use in

any non-approved way.
Any unauthorized modification to this

device could void the user's authority to

operate the equipment.

i

Canada only: This device complies with

RSS-210 of Industry Canada. Operation is

subject to the following two conditions:
1. This device may not cause harmful inter-

ference, and
2. This device must accept any interference

received, including interference that may

cause undesired operation of the device.
Removal, tampering, or altering of the

device will void any warranties, and is not

permitted. Do not tamper with, alter, or use

in any non-approved way.
Any unauthorized modification to this

device could void the user's authority to

operate the equipment.

Radar sensors
The Active Blind Spot Assist radar sensors are

integrated into the front and rear bumpers

and behind a cover in the radiator trim. Make

sure that the bumpers and the cover in the

radiator grill are free of dirt, ice or slush. The

rear sensors must not be covered, e.g. by

bicycle racks or overhanging loads. Following

a severe impact or in the event of damage to

the bumpers, have the function of the radar

sensors checked at a qualified specialist

workshop. Active Blind Spot Assist may oth-

erwise no longer work properly.

Monitoring area

G

WARNING

Active Blind Spot Assist does not detect all

traffic situations and road users. There is a

risk of an accident.
Always make sure that there is sufficient dis-

tance on the side for other traffic or obstacles.

Active Blind Spot Assist monitors the area up

to 10 ft (3.0 m) behind your vehicle and

directly next to your vehicle, as shown in the

diagram.
The detection of obstacles can be impaired in

the case of:

R

there is dirt on the sensors or anything else

covering the sensors

R

poor visibility, e.g. due to rain, snow or

spray

Vehicles in the monitoring range are then not

indicated.
Active Blind Spot Assist may not detect nar-

row vehicles, such as motorcycles or bicy-

cles, or may only detect them too late.
If the lanes are narrow, vehicles driving in the

lane beyond the lane next to your vehicle may

be indicated, especially if the vehicles are not

driving in the middle of their lane. This may be

the case if there are vehicles at the inner edge

of your lane.

218

Driving systems

Dr

ivi

ng

an

d

parki

ng

Advertising