Mercedes-Benz S-Coupe 2015 - Manual (Page 269)

Display messages Possible causes/consequences and M M Solutions
¨
Vehicle Rising Vehicle Rising
Please Wait Please Wait
The vehicle level is too low when the vehicle is stationary. A warn-
ing tone also sounds.
X
Do not pull away.
The vehicle level is set when the display message disappears.
¨
Stop Vehicle Vehi‐ Stop Vehicle Vehi‐
cle Too Low cle Too Low
You have pulled away while the vehicle level is still too low.
AIRMATIC sets the vehicle to the selected level after a short
period.
X Pull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions.
X
Secure the vehicle against rolling away (
Y
page 166).
X
Wait until the display message disappears before pulling away.
AIRMATIC is defective. A warning tone also sounds.
X
Do not drive at speeds above 50 mph (80 km/h).
X
Make only slight steering movements. Otherwise, the front
fender or the tires could be damaged if the steering movement
is too large.
X
Listen for scraping sounds.
X
Pull over and stop the vehicle safely, paying attention to road
and traffic conditions, and select a higher vehicle level.
Depending on the malfunction, it may be possible to raise the
vehicle.
X
Visit a qualified specialist workshop.
¨
Malfunction Malfunction
The AIRMATIC function is restricted. The vehicle's handling char-
acteristics may be affected.
X
Do not drive at speeds above 50 mph (80 km/h).
X
Visit a qualified specialist workshop.
ABC Malfunction ABC Malfunction
Stop Vehicle Stop Vehicle
The Active Body Control (ABC) vehicle level is too low.
X
Pull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions.
After a few seconds, the vehicle level is adjusted and the display
message disappears.
The vehicle is leaking oil.
The display message is shown continuously.
X
Pull over and stop the vehicle safely as soon as possible, paying
attention to road and traffic conditions. Do not continue driving
under any circumstances.
X Consult a qualified specialist workshop.
Display messages
267
On-board
computer
and
displays
Z