Sewing machine no. 15 – SINGER 15-30 Treadle Sewing Machine User Manual

Page 28

Advertising
background image

Table of Contents

Previous Page | Next Page

Sewing Machine No. 15

28

Line 1 - the correct position for the material

to which the ruffled material is
applied.

Line 2 - material to be willed.
Line 3 - the facing for the ruffle.
Line 4 - the strip of piping material.
Line 5 - the edge to be piped.

Refer to Fig. 26 when inserting the material in
the ruffler.

The names and uses of the principal parts of
the ruffler are as follows:

(SEE REFERENCES IN FIG. 26)

A - FOOT - the part by which the ruffler is
attached to the presser bar.

B - FORK ARM - the section that must be
placed astride the needle clamp.

C - ADJUSTING SCREW - the screw that
regulates the fullness Of the gather.

D - PROJECTION - the part that projects
through the slots in the adjusting lever.

E - ADJUSTING LEVER - the lever that sets
the ruffler for gathering or for making a plait
once at every six stitches or once at every
twelve stitches, as desired; also for disengag-
ing the ruffler, when either plaiting or gather-
ing is not desired.

F - ADJUSTING FINGER - the part which
regulates the width or size of the plaits.

G - SEPARATOR GUIDE - the guide on the
underside of the ruffles, containing slots into
which the edge of the material is placed to
keep the heading of the ruffle even; also for
separating the material to be ruffled from the
material to which the ruffle is to be attached.

H - RUFFLING BLADE - the upper blue steel
blade with the teeth at the end to push the
material in plaits up to the needle.

J - SEPARATOR BLADE - the lower blue
steel blade without teeth, which prevents the
teeth of the ruffling blade coming into contact
with the feed of the machine, or the material
to which ruffle or plaiting is to be applied.

Advertising
This manual is related to the following products: