SINGER 15-30 Treadle Sewing Machine - Manual (Page 34)

Table of Contents Previous Page | Next Page
Sewing Machine No. 15
34
To Adjust the Ruffler for Plaiting
Raise the adjusting lever (E, Fig. 31) and move it to the right so that the projection (D, Fig.
31) will enter the slot marked "6" in the adjusting lever when the lever is released. The ruffling
blade will then move forward and back once at every six stitches. To adjust the ruffling blade
to make a plait once at every twelve stitches, place the adjusting lever (E, Fig. 31) so that the
projection (D) enters the slot marked "12" in the adjusting lever. Insert the material to be
plaited between the two blue blades, following the line (2, Fig. 26). The size or width of plaits
is regulated by the adjusting screw. (C, Fig. 31) and the adjusting finger (F. Fig. 31). To make
a wider plait, move the adjusting finger (F) back or toward needle and turn the adjusting
screw (C) downwardly. To make a smaller a smaller plait, turn the adjusting screw (C)
upwardly. The distance between plaits is regulated by the length of stitch.
Fig. 31