SINGER 15-30 Treadle Sewing Machine - Manual (Page 7)

Table of Contents Previous Page | Next Page
Sewing Machine No. 15
7
To Wind the Bobbin
Release the balance wheel (4, Fig. 3) by turning the stop motion screw (5, Fig. 3) over toward you.
FIG. 5. MACHINE THREADED FOR WINDING THE BOBBIN
Place the bobbin on the bobbin winder spindle (8, Fig. 6) and push it up closely against the
shoulder, having the small pin in the spindle enter the slot in the side of the bobbin. Put the
spool of thread on the spool pin (1, Fig. 5). Pass the end of the thread into the thread guide
(2, Fig. 5) at the left and near the top of the arm, then up into the lower eyelet (3, Fig. 6) of
the bobbin winder thread guide, into the notch (4, Fig. 6) and pass the thread through the slot
in the left side of the bobbin from the inside. Press the bobbin winder pulley (5, Fig. 6) down
on the balance wheel hub, and the latch (7, Fig. 6) will drop down and hold it. Then operate
the treadle the same as for sewing.