Wine Guardian Ducted Split Wine Cellar Cooling Systems (WGS175) - Manual - Manual (Page 24)

26
WARNING

Check weights to be sure that the rigging equipment can support and move the Wine
Guardian unit safely. Note any specific rigging and installation instructions located in
the Installation section of this manual.

All supports for the unit must be capable of safely supporting the equipment’s weight
and any additional live or dead loads encountered.

All supports for the unit must be designed to meet applicable local codes and
ordinances.

Do not remove access panels until fan impellers have completely stopped.
Pressure developed by moving impellers can cause excessive force against the
access panels.

Fan impellers continue to turn (free-wheel) after the power is shut off.
CAUTION

Clean only with a dry cloth.

Never pressurize equipment above specified test pressure. See Wine Guardian
Specification sheet on page 13.

Do not use the Wine Guardian near water.

Do not block any supply or return air register or duct. Install in accordance
with the instructions in this manual. Do not defeat the safety purpose of the
polarized or grounding type plug. A polarized plug has two blades with one
wider than the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong is provided for your safety.
If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.

Protect the power cord from being walked on or pinched, particularly at the
outlet plugs, convenience receptacles, and the point where it exits the unit.

Only use attachments/accessories specified by the manufacturer.

Always operate this equipment from a 120/230 VAC, 1 phase, 50Hz power
sources only.

Always ground the outlet to provide adequate protection against voltage surges
and built-up static charges.

Refer all servicing to qualified service personnel. Servicing is required when
the unit has been damaged in any way.