Wine Guardian Ducted Split Wine Cellar Cooling Systems (WGS175) - Manual - Manual (Page 47)

49
Installation of the Wine Guardian Remote Sensor
The Remote Sensor is a combination temperature and
humidity sensor only. It is designed to be mounted within
the wine cellar and can be used in combination with the
Remote Interface Controller or up to three additional
Remote Sensors to read and control multiple areas within
the wine cellar.
Mounting the remote sensor
Disconnect the communication cable from the side of the Wine
Guardian unit and the remote sensor. Install the communication
cable within the wall and/or ceiling structure of the wine cellar
to the desired controller mounting location.
Important
A splitter device has been supplied within the Remote Sensor kit. The splitter device
must be mounted at the WG unit as shown. DO NOT mount the splitter device at the
back of the Remote Interface Controller or to the back of the Remote Sensor as this
WILL cause component or system damage
Fig.1