Wine Guardian Ducted Split Wine Cellar Cooling Systems (WGS175) - Manual - Manual (Page 44)

46
Installing the Thermostat and Communication Cable
The Wine Guardian Remote Interface
Controller is a combination temperature and
humidity controller with single stage cooling,
heating and humidifier control. Each Wine
Guardian unit is supplied with a Remote
Interface Controller and 50 feet of
communication cable. It is wired at the
factory for testing prior to shipment.
In most applications the Remote Interface Controller will be mounted within the wine cellar.
The remote interface controller can also be mounted directly outside of the wine cellar or in
any other room of the home or building. When mounted outside of the wine cellar, a remote
sensor kit must be purchased and installed within the wine cellar. See below for remote sensor
installation details.
IMPORTANT
Wine Guardian units are supplied with 6m of Cat 3, 6-wire twisted pair
communication cable with RJ-11 connectors. Failure to use this type of
communication cable WILL cause product damage and WILL void any
equipment warranty.
Installation instructions should be followed CAREFULLY as improper splicing
and/or joining of twisted pair cables can cause equipment failure.