CANOGA PERKINS 9175 Configuration Guide - Manual (Page 117)

CanogaOS Configuration Guide
18-6
DUT#configure terminal Enter the Configure mode.
DUT(config-if) # no switchport Configure on physical port only, change this port to Layer3
interface.
DUT(config-if) # ip address 1.1.1.1/24 Configure IP address to 1.1.1.1/24.
DUT(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT(config)#interface loopback 0 Specify the interface (loopback 0)to be configured and enter
the Interface mode.
DUT(config-if) # ip address 10.10.10.10/32 Configure IP address to 10.10.10.10/32.
DUT(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT(config)# ip route 11.11.11.11/32 1.1.1.2 Add a static route 11.11.11.11/32 with nexthop 1.1.1.2
DUT(config)#interface eth-0-1 Specify the interface (eth-0-1)to be configured and enter the
Interface mode.
DUT (config-if)# no shutdown Enable the interface.
DUT(config-if) # no switchport Configure on physical port only, change this port to Layer3
interface.
DUT(config-if) # ip address 2.2.2.1/24 Configure IP address to 2.2.2.1/24.
DUT(config-if)#exit Exit the Interface mode and enter the Configure mode.
DUT(config)#ip route 3.3.3.0/24 2.2.2.2 Add a static route 3.3.3.0/24 with nexthop 2.2.2.2
DUT(config)#router bgp 100 Creat bgp 100 and enter the router mode
DUT(config-router)#bgp router-id 10.10.10.10 Configure the bgp router-id
DUT(config-router)#neighbor 11.11.11.11
remote-as 100 Configure the ibgp neighbor with as 100
DUT(config-router)#neighbor 11.11.11.11
update-source loopback 0 Configure the loopback 0 to be the update-source interface
DUT(config-router)#network 4.0.0.0/8 Network the specified route 4.0.0.0/8
DUT(config-router)#redistribute static Redistribute the static route into bgp
DUT(config-router)#redistribute connected Redistribute the connect route into bgp
DUT(config-router)#exit Exit the router mode and enter the Configure mode.