CANOGA PERKINS 9175 Configuration Guide - Manual (Page 187)

CanogaOS Configuration Guide
29-4
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-17 Enter the Interface mode.
• eth-0-17—Specify the interface
DUT1(config)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#ip address 11.11.17.3/24 Create IP address on the port.
DUT1(config-if)#enable-ldp Configure Interface for LDP.
DUT1(config-if)#label-switching Enable label-switching on interface.
DUT1(config-if)#exit Exit the Interface mode
DUT1(config)# interface loopback 0 Enter the Interface mode.
• loopback0—Specify the loopback interface
name.
DUT1(config-if)#ip address 11.11.3.3/32 Create loopback addresses on both PE
routers. Use a /32 host route for the loopback
address.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)# router ldp Enter the router-ldp mode.
DUT1(config-router)#transport-address 11.11.3.3 Configure the transport address for a label
space.
DUT1(config-router)#targeted-peer 11.11.1.1 Configure Targeted Peer.
DUT1(config-router)#targeted-peer 11.11.4.4 Configure Targeted Peer.
DUT1(config)#exit Exit the router-ldp mode.
DUT1(config)# router rip Enter the router-rip mode
DUT1(config-router)#network 11.11.1.1/16 Associate networks with the RIP process.
DUT1(config-router)# exit Exit the router-rip mode.
DUT1(config)#mpls vpls-vlan 4000 4010 Create a block of continuous vlan id which
used for vpls function.
DUT1(config)#mpls vpls v3 100 Create a VPLS instance and come into the
VPLS instance mode.
DUT1(config-vpls)#vpls-peer 11.11.1.1 raw Add a PE for VPLS instance.
DUT1(config-vpls)#vpls-peer 11.11.4.4 raw Add a PE for VPLS instance.
DUT1(config-vpls)#exit Exit VPLS instance mode.
DUT1(config)#interface eth-0-1 Enter the Interface mode
• eth-0-1—Specify the interface
DUT1(config-if)#mpls-vpls v3 Bind an interface to a VPLS instance.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)#interface eth-0-2 Enter the Interface mode
• eth-0-2—Specify the interface