3 validation commands – CANOGA PERKINS 9175 Configuration Guide User Manual

Page 88

Advertising
background image

CanogaOS Configuration Guide

14-2

14.3 Validation commands

Verify the arp entries

DUT#show ip arp
Protocol Address Age (min) Hardware Addr Interface
Internet 11.11.11.1 - 48c9.86ab.6b00 eth-0-1
Internet 11.11.11.2 - 001a.a011.eca2 eth-0-1
Internet 11.11.11.3 0 001a.a011.eca3 eth-0-1
DUT1#show ip arp summary
3 IP ARP entries, with 0 of them incomplete


Verify the ARP request retry delay time and age period on interface eth-0-1

DUT#show interface eth-0-1
Interface eth-0-1
Interface current state: UP
Hardware is Ethernet, address is 48c9.86ab.6b00 (bia 48c9.86ab.6b00)
Bandwidth 1000000 kbits
Index 106 , Metric 1 , Encapsulation ARPA
Speed - 1000Mb/s , Duplex - Full , Media type is 1000BASE_T
Link speed type is autonegotiation, Link duplex type is autonegotiation
Input flow-control is off, output flow-control is off
The Maximum Frame Size is 1534 bytes
VRF binding: not bound
Label switching is enabled with label-space 0
minimum label value configured is 16
maximum label value configured is 1048575
No virtual circuit configured
VRRP master of : VRRP is not configured on this interface
ARP timeout 00:20:00, ARP retry interval 2s
Internet primary address:
11.11.11.1/24 broadcast 11.11.11.255
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
5 packets input, 210 bytes
Received 0 broadcasts (0 multicast)
0 runts, 0 giants, 0 input errors, 0 CRC
0 frame, 0 overrun, 0 pause input
0 input packets with dribble condition detected
1 packets output, 46 bytes, 0 underruns
0 output errors, 0 collisions, 0 late collision
0 no carrier, 0 pause output

Advertising