CANOGA PERKINS 9175 Configuration Guide - Manual (Page 194)

CanogaOS Configuration Guide
30-1
30 Configuring MPLS OAM
30.1 Overview
This chapter contains configuration for MPLS Operations, Administration and
Management (OAM). MPLS OAM is used to detect forwarding plane failures in an MPLS
network.
Similar to ICMP echo requests and replies in an IP network, an MPLS network can have
MPLS echo requests and replies for checking the data plane and control plane
operations in the Label Switched Path (LSP). The MPLS traceroute process also
provides path details for the LSP.
30.2 Validating LDP IPv4 FEC
30.2.1 Configurations on PE1
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)# interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)# no switchport Configure the port to layer 3 port.
DUT1(config-if)# enable-ldp Configure Interface for LDP
DUT1(config-if)# ip address 1.1.1.1/24 Create IP address on the port.
DUT1(config)#exit Exit the Interface mode.
DUT1(config)# interface eth-0-12 Enter the Interface mode.
• eth-0-12—Specify the interface
DUT1(config-if)# no switchport Configure the port to layer 3 port.
DUT1(config-if)# enable-ldp Configure Interface for LDP
DUT1(config-if)# ip address 2.2.2.1/24 Create IP address on the port.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)# router ldp Enter the router-ldp mode.
DUT1(config-router)# exit Exit the router-ldp mode.
DUT1(config)# router rip Enter the router-rip mode
DUT1(config-router)# network 1.1.1.0/24 Associate networks with the RIP process.
DUT1(config-router)# network 2.2.2.0/24 Associate networks with the RIP process.
DUT1(config-router)#exit Exit the router-rip mode.
DUT1(config)#mpls enable-all-interfaces Enable label-switching on all interfaces.