CANOGA PERKINS 9175 Configuration Guide - Manual (Page 64)

CanogaOS Configuration Guide
9-18
DUT(config) # interface eth-0-13 Enter the Interface mode.
DUT(config-vlan) # exit Exit the interface mode and enter the Configure mode.
Configure and enable ERPS domain
DUT(config) # erps 2 Create erps domain with id 2.
DUT(config) # erps 2 primary control vlan 12 Set vlan 12 as the primary control vlan of erps domain
2.
DUT(config) # erps 2 ring 1 level primary Create an erps primary ring 1 for domain 2.
DUT(config) # erps 2 ring 1 mode master Set node as master of ring 1 for domain 2.
DUT(config) # erps 2 ring 1 primary interface eth-0-9 Set primary interface of ring 1 for domain 2.
DUT(config)# erps 2 ring 1 secondary interface eth-0-13 Set secondary interface of ring 1 for domain 2.
DUT(config) # erps 2 ring 1 enable Enable ring 1 for domain 2.
DUT(config) # erps 2 enable Enable domain 2.
9.5.3 Validation Commands
Switch 1
DUT #show erps 1
ERPS domain ID: 1
ERPS domain name: ERPS001
ERPS domain primary control VLAN ID: 11
ERPS domain sub control VLAN ID: 0
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 3 second(s)
ERPS ring ID: 1
ERPS ring level: primary
ERPS ring 1 node mode: master
ERPS ring 1 node state: complete
ERPS ring 1 primary interface name: eth-0-9
ERPS ring 1 secondary interface name: eth-0-13
Switch 2
DUT #show erps 1
ERPS domain ID: 1
ERPS domain name: ERPS001
ERPS domain primary control VLAN ID: 11
ERPS domain sub control VLAN ID: 0
ERPS domain hello timer interval: 1 second(s)
ERPS domain fail timer interval: 3 second(s)
ERPS ring ID: 1
ERPS ring level: primary
ERPS ring 1 node mode: transit
ERPS ring 1 node state: link up
ERPS ring 1 primary interface name: eth-0-9
ERPS ring 1 secondary interface name: eth-0-20
DUT #show erps 2
ERPS domain ID: 2
ERPS domain name: ERPS002
ERPS domain primary control VLAN ID: 12
ERPS domain sub control VLAN ID: 0
ERPS domain hello timer interval: 1 second(s)