CANOGA PERKINS 9175 Configuration Guide - Manual (Page 202)

CanogaOS Configuration Guide
30-9
Command Description
routing table
DUT1(config-vrf)#rd 1:100 Assign a route distinguisher (RD) for the VRF.
DUT1(config-vrf)#route-target both 1:100 Add a list of import and export route-target
extended communities to the VRF.
DUT1(config-vrf)#exit Exit VPN routing and forwarding(VRF) routing
table.
DUT1(config)# router ldp Enter the router-ldp mode.
DUT1(config-router)# targeted-peer 11.11.11.11 Configure Targeted Peer in LDP.
DUT1(config-router)# transport-address 10.10.10.10 Configure Transport Address in LDP.
DUT1(config-router)# exit Exit the router-ldp mode.
DUT1(config)#interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)#no switchport Configure the port to layer 3 port.
DUT1(config-if)#ip vrf forwarding vpn1 Associate a VPN routing and
forwarding(VRF)instance with an Layer3
interface.
DUT1(config-if)#ip address 1.1.1.1/24 Create IP address on the port.
DUT1(config-if)#exit Exit the Interface mode.
DUT1(config)# router rip Enter the router-rip mode
DUT1(config-router)# network 10.10.10.10/32 Associate networks with the RIP process.
DUT1(config-router)# network 2.2.2.0/24 Associate networks with the RIP process.
DUT1(config-router)#exit Exit the router-rip mode.
DUT1(config)#mpls enable-all-interfaces Enable label-switching on all interfaces.
DUT1(config)#router bgp 1 Configure a BGP routing process.
DUT1(config-router)#bgp router-id 10.10.10.10 Configure the router identifier.
DUT1(config-router)#neighbor 11.11.11.11 remote-as
1 Configure an internal or external BGP (iBGP or
eBGP) TCP session with another router.
DUT1(config-router)#neighbor 11.11.11.11
update-source loopback0 Allow internal BGP sessions to use any
operational interface for TCP connections.
DUT1(config-router)#address-family vpnv4 unicast Enter the VPNv4 address-family command mode.
DUT1(config-router-af)#neighbor 11.11.11.11 activate Enable the exchange of the specified AF routes
with a neighboring router.
DUT1(config-router-af)#neighbor 11.11.11.11
send-community both Specify that a community attribute should be sent
to a BGP neighbor.
DUT1(config-router-af)#exit-address-family Exit the address family mode.
DUT1(config-router)#address-family ipv4 Enter the IPv4 address-family command mode.
DUT1(config-router-af)#neighbor 11.11.11.11 activate Enable the exchange of the specified AF routes
with a neighboring router.