CANOGA PERKINS 9175 Configuration Guide - Manual (Page 181)

CanogaOS Configuration Guide
28-2
28.2.2 Configuring the VPWS on PE2
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)#interface eth-0-2 Enter the Interface mode.
• eth-0-2—Specify the interface
DUT1(config-if)#mpls-l2-circuit t1 ethernet Bind an interface to the Virtual Circuit.
DUT1(config-if)# exit Exit the Interface mode.
DUT1(config)# interface loopback 0 Enter the Interface mode.
• loopback0—Specify the loopback interface
name.
DUT1(config-if)#ip address 192.168.11.10/32 Create loopback addresses on both PE routers.
Use a /32 host route for the loopback address.
DUT1(config)#exit Exit the Configure mode.
DUT1(config)# router ldp Enter the router-ldp mode.
DUT1(config-router)# targeted-peer 192.168.10.10 Configure Targeted Peer in LDP.
DUT1(config-router)#exit Exit the router-ldp mode.
DUT1(config)# mpls l2-circuit t1 200 192.168.10.10 Create a Virtual Circuit.Both PE routers must be
configured with the same VC-ID (200).
DUT1(config)# interface eth-0-1 Enter the Interface mode.
• eth-0-1—Specify the interface
DUT1(config-if)# no switchport Configure the port to layer 3 port.
DUT1(config-if)#ip address 8.8.8.2/24 Create IP address on the port.
DUT1(config-if)# enable ldp Configure Interface for LDP.
DUT1(config-if)# label-switching Enable label-switching on interface
28.2.3 Validation Commands
Use the show mpls l2-circuit and the show mpls vc-table commands respectively to
display complete information about the Layer-2 Virtual Circuit. The following are the
sample outputs for the show commands displaying Layer-2 virtual circuit information.
On PE1
DUT1#show mpls l2-circuit
VC-Name VC-ID Interface VC-type VLAN C-Word Manual
t1 200 eth-0-1 Ethernet N/A 0 No
DUT1#show mpls vc-table
VC-ID In Intf Out Intf In Label Out Label EndPoint Status Manual
200 eth-0-2 eth-0-1 3328 3328 192.168.11.10 Active No
On PE2
DUT1#show mpls l2-circuit
VC-Name VC-ID Interface VC-type VLAN C-Word Manual
t1 200 eth-0-1 Ethernet N/A 0 No