CANOGA PERKINS 9175 Configuration Guide - Manual (Page 169)

CanogaOS Configuration Guide
26-2
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)# interface eth-0-17 Enter the Interface mode.
• eth-0-17—Specify the interface
DUT1(config-if)# no switchport Configuring the port as layer 3 port.
DUT1(config-if)# ip address 11.11.17.2/24 Create IP address on the port.
DUT1(config-if)# enable-ldp Configuring Interface for LDP.
DUT1(config-if)# label-switching Enable label-switching on interface.
DUT1(config-if)#exit Exit the Configure mode.
DUT1(config)#router ldp Enter the router-ldp mode.
DUT1(config-router)#exit Exit the router-ldp mode.
DUT1(config)#router rip Enter the router-rip mode.
DUT1(config-router)#network 11.11.1.1/16 Associate networks with the RIP
process.
DUT1(config-router)#exit Exit the router-rip mode
DUT1(config)#interface eth-0-9 Enter the Interface mode.
• eth-0-9—Specify the interface
DUT1(config-if)#no switchport Configuring the port as layer 3 port.
DUT1(config-if)#ip address 11.11.9.1/24 Create IP address on the port.
DUT1(config-if)#enable-ldp Configuring Interface for LDP.
DUT1(config-if)#label-switching Enable label-switching on interface.
Configure lsr-c
Beginning in privileged EXEC mode, follow these steps to configure the LDP:
Command Description
DUT1#configure terminal Enter the Configure mode.
DUT1(config)# interface eth-0-9 Enter the Interface mode.
• eth-0-9—Specify the interface
DUT1(config-if)# no switchport Configuring the port as layer 3 port.
DUT1(config-if)# ip address
11.11.9.2/24 Create IP address on the port.
DUT1(config-if)# enable-ldp Configuring Interface for LDP.
DUT1(config-if)# label-switching Enable label-switching on interface.
DUT1(config-if)#exit Exit the Configure mode.
DUT1(config)#router ldp Enter the router-ldp mode.
DUT1(config-router)#exit Exit the router-ldp mode.
DUT1(config)#router rip Enter the router-rip mode