CANOGA PERKINS 9175 Configuration Guide - Manual (Page 7)

CanogaOS Configuration Guide
iii
10.5 Understanding layer2 protocol tunneling ................................................. 10-5
10.6 Layer2 protocol tunneling Configuration .................................................. 10-5
11 Configuring CFM............................................................................................ 11-1
11.1 Overview ................................................................................................. 11-1
11.2 References .............................................................................................. 11-1
11.3 Topology.................................................................................................. 11-2
11.4 Configurations ......................................................................................... 11-2
11.5 Validation Commands ............................................................................. 11-6
12 Configuring EFM OAM................................................................................... 12-1
12.1 Overview of EFM OAM configuration ...................................................... 12-1
12.2 References .............................................................................................. 12-1
12.3 Topology.................................................................................................. 12-1
12.4 Configuration ........................................................................................... 12-1
12.5 Remote Loopback Configuration ............................................................. 12-4
12.6 Link Monitoring Event Configuration........................................................ 12-5
12.7 Remote Failure Detection Configuration.................................................. 12-6
13 Configuring Layer3 Interfaces........................................................................ 13-1
13.1 Overview ................................................................................................. 13-1
13.2 Configuring routed port............................................................................ 13-1
13.2.1 Configurations............................................................................. 13-1
13.2.2 Validation Commands ................................................................. 13-1
13.3 Configuring VLAN interfaces ................................................................... 13-2
13.3.1 Configurations............................................................................. 13-2
13.3.2 Validation Commands ................................................................. 13-2
13.4 Configuring Layer 3 link aggregation interfaces ...................................... 13-3
14 Configuring ARP ............................................................................................ 14-1
14.1 Overview ................................................................................................. 14-1
14.2 Configuring ARP...................................................................................... 14-1
14.3 Validation commands .............................................................................. 14-2
15 Configuring IP Unicast-Routing...................................................................... 15-1
15.1 Enabling Static Routing ........................................................................... 15-1
16 Configuring RIP ............................................................................................. 16-1
16.1 Overview ................................................................................................. 16-1
16.2 Enabling RIP ........................................................................................... 16-1
16.3 Specifying the RIP version ...................................................................... 16-2
16.4 Configuring Metric Parameters ................................................................ 16-3
16.5 Changing the Administrative Distance..................................................... 16-4
16.6 Configuring Redistribution ....................................................................... 16-4
16.7 Configuring Split-horizon Parameters...................................................... 16-5
16.8 Configuring Timers .................................................................................. 16-5
16.9 Configuring RIP Route Distribute Filters.................................................. 16-6
16.10 RIPv2 authentication (single key) ............................................................ 16-6
16.11 RIPv2 MD5 authentication (multiple keys)............................................... 16-7
17 Configuring OSPF.......................................................................................... 17-1
17.1 Overview ................................................................................................. 17-1
17.2 References .............................................................................................. 17-1