Yamaha HTR-6080 - Manual (Page 104)

Troubleshooting
During AUTO SETUP
Error incss.'igc C.'iuse Romocly
See
page
IE
..
:l.
::
HO Fl'iCiifT iFI"-' Front E/R channel signals are not detected. Check the front L/R speaker connections. 13
|r
.... V
¡1 i!!r| ||!!!i CT!!'
A surround channel signal is not detected. Check the surround speaker connections. 13
L
.... •: II i'.Jf 1 ¡.„•L.it.Ji... 1,.. I...I A presence channel signal is not delected. Check the presence speaker connections. 13
Only a right surround back channel signal is
detected. Conned the surround back speaker to the
LEFT SURROUND BACK SPEAKERS
terminal if you only have one surround
back speaker.
13
p......
i-j ¡1 T ert.i
Background noise is too loud. Tr>' running “AUTO SETUP” in a quiet
environment.
Turn off noisy electric equipment like air
conditioners or move them away from the
optimizer microphone.
p......|;!( ¡[ '“H i|!p Surround back speakers are connected,
though surround L/R speakers are not. Connect surround speakers when you use
surround back speakers. 13
u......■'/ II i'.jri i'ti T ("■' The optimizer microphone was unplugged
during the “'AUTO SETUP“ procedure. Connect the supplied optimizer microphone
to the OPTIMIZER MIC jack on the front
panel. 28
u......O II i'.jri 'lir T ("!;i'.3i"‘(! The optimizer microphone does not detect Check the microphone setting. 28
test tones.
Check the speaker connections and
placement. 13
pr
.. Cj « I i"''j“n-.U"''
pr
j The “AUTO SETUP” procedure was
cancelled due to user activity. Run "AUTO SETUP” again. 28
pr.'j ¡1 1 kr'ri!!!'p!!'kn|Vi priipipni!1 An internal error occurred.
Run “AUTO SETUP“ again. 28
After AUTO SETUP
Wi^rnlng mess.^ge Cause Remedy
Soe
pnge
" i II I ; I If,,. i,.,'i,„ii Speaker polarity is not correct. This
message may appear depending on the
speakers even when the speakers are
connected correctly.
Check the speaker connections for proper
polarity (+ or ■
The disUince between the speaker and the
listening position is over 24 m (SO ft).
Bring the speaker closer to the listening
position.
The difference of volume level among
speakers is excessive. Readjust the speaker installation so that all
speakers are set in locations with similar
conditions.
Check the speaker connections.
Use speakers of similar quality.
Adjust the output volume of the subwoofer. 2S
II f 'Ì...II... I 'f.-' "EXTRA SP ASSIGN" is sel to
"PRESENCE”, though the presence
channel signals are not detected. Cheek the presence speaker connections. 13
Set "EXTRA SP ASSIGN" to a setting
other than "PRESENCE'.
"
Notes
• If the ‘'ERROR'' or “WARNING" screens appears, check the cause of the problem, then run “AUTO SETUP" again.
• If a wyirning itiessagc ‘'W-1 appears, corrections are made, but they ntay not be optimal.
• If a warning message “W-2" or “W-3" appears, no corrections arc made.
• If an error message “E-10" occurs repeatedly, contact a qualified Yamaha service center.
100
En