Yamaha HTR-6080 - Manual (Page 29)

Connections
Setting the speaker impedance
Caution
If you are to use 6 ohm speakers, set “SP IMP.” to
“6Q MIN” as follows BEFORE using this unit. 4 ohm
speakers can be also used as the front speakers.
1
Make sure this unit is turned off.
Refer to the right column for details.
2
Press and hoid ©TONE CONTROL on the
front panel and then press ©STANDBY/ON
inward to the ON position to turn on this unit.
This unit turns on, and the advanced setup menu
appears in the front panel display.
Turning this unit on and off
■ Turning on this unit
Press ©STANDBY/ON on the front panel to turn
on this unit.
When you turn on thi-s unit, there will be a 4 to 5-second delay
before this unit can reproduce sound.
■ Set this unit to the standby mode
Press ©STANDBY/ON (or ©STANDBY) to
set this unit to the standby mode.
[n the standby mode, this unit consumes a small amount of
power in order to receive infrared signals from the remote
control.
TONE CONTROL
While holding
down / ' X k
3
Rotate the ©PROGRAM selector on the
front panel to select “SP IMP.”.
“SP IMP.” and the current speaker impedance setting
(“80 MIN”) appear in the front panel display.
4
Press @TONE ^ qi ^ t ROL on the front
panel repeatedly to select “60 MIN”.
5
Press ©STANDBY/ON on the front panel to
save the new setting and turn off this unit.
Note
The selling you made is reflected next time you luni on this
unit.
' You can also turn on this unit by pressing ©SCENE (or
©SCENE) buuoiis.
' When you uirn on this unit, there will be a 4 to .5-sect)nd delay
before this unit etin rcprttdtiee sound.
25
En