Yamaha HTR-6080 - Manual (Page 80)

Customizing this unit (MANUAL SETUP)
Center graphic equalizer CiElfTEf?
Lise to match the tonal quality of the center speaker with
that of the front left and right speakers. You can adjust 5
frequency bands (100 Hz, 300 Hz, 1 kHz, 3 kHz and
10 kHz).
Control range: -6.0 to 6.0 dB
Control step: 0..5 dB
Initial setting: 0.0 dB
11-. 11I...
Press ® A / V to select a frequency band and ® <1 /1>- to adjust
the selected frequency band.
Note
The “CENTER GEQ“ parameter can be adjusted only when
“CENTER GEQ’^ is selected in “EQ TYPE SELECT”.
■ Low-frequency effect level
I!!!' ''j I i |u'|
Use this feature to adjust the output level of the LFE (low-
frequency effect) channel according to the capacity of
your subwoofer or headphones, fhe LFE channel carries
low-frequency special effects which are only added to
certain scenes. This setting is effective only when this unit
decodes Dolby Digital or DTS signals.
Control range: -20 to
0 dB
Control step: 1 dB
SOUND NENU
'
E)LFE L.EUEL,
SPEAKER..........II
HEADPHONE« ” = e
dE
dB
[A3,.-tT] II UF..-DOI T
2 Adjust
Speaker iBFdEHKEiR
Adjusts the speaker LEE level.
Headphone HEflDi-1-iOHIE
Adjusts the headphone LEE level.
Note
Depending on the settings of "LFE/BASS OUT” (see page 72),
some signals may not he oalptit at the SUBWOOFER OUTPUT
jack.
■ Dynamic range F )DvNii
Use this feature to select the amount of dynamic range
compression to be applied to your speakers or
headphones. This setting is effective only when this unit is
decoding Dolby Digital and DTS signals.
Choices: .MIN, STD,
MAX
• Select “MIN” (minimum) if you regularly listen at low
volume levels.
• Select “STD” (standard) for general use.
• Select “MAX” (maximum) to preserve the greatest
amount of dynamic range.
FiJDVHPMIC: R h HGE
bP: PUN bTD>MfiP!
HP'S PUN
[.».]--'[T]!Up/Down
Sbeiect,
Speaker SF'
Adjusts the speaker compression.
Headphone UF'
Adjusts the headphone compressit.>n.
■ Audio settings iBfflUDiO ; e ; e T
Use this feature to adjust the overall audio settings of this
unit.
bOLIPC PIENLi
ePRUDIO SET
PILITiNG TYPE-FULL
H. DbL.flV flpis
Pia:>i i.tOL.-+16.5dE
IHI.i.J0L.--.--i;iFF
[”4] f i i'01
Muting type ilUTE ivF-1:L
Use this feature to adjust how much the mute function
reduces the output volume (see page 40).
Choices:
FULL, -20dB
• Select “PULL” ((, completely mute all the audio
output.
• Select “-20dB” to reduce the current volume by 20 dB.
Audio delay l-h,
Use this feature to delay the sound output and synchronize
it with the video image. This may be necessary when
using certain LCD monitors or projectors.
Control range: Oto 160ms
Control step: 1 ms
76
En