Yamaha HTR-6080 - Manual (Page 18)

Connections
■ Connecting the speaker cable
1
Remove approximately 10 mm (0.4 in) of
insulation from the end of each speaker
cable and then twist the exposed wires of the
cable together to prevent short circuits.
10 mm (0.4 in)
' jjjjjjj
■ Connecting the banana plug
Tighten the knob and then insert the banana plug
connector into the end of the corresponding
terminal.
2
Loosen the knob. Black: negative {-)
Using bi-amplification connections
Red: positive (+)
Biack: negative (-
3
Insert one bare wire into the hole on the side
of each terminal.
4
Tighten the knob to secure the wire.
Caution
Remove the shorting bars or bridges of your speakers
to separate the LPF (low pass filter) and HPF (high
pass filter) crossovers.
This unit allows you to make bi-amplification connections
to one speaker system. Check if your speakers support bi-
aniplification.
To make the bi-amplification connections, use the FRONT
and SURROUND BACK/Bl-A.MP terminals as shown
below. To activate the bi-amplification connections, set
“Bl-AMP” to “ON" in “ADVANCED SETUP” (see
page 93),
Front speakers
Right Lett
Note
When you make the conventional connection, make sure that the
shorting bars are pul into the terminals appropriately. Refer to the
instruction manuals of the speakers tor details.
14 En