Panasonic 7 - Manual (Page 101)

Chapter 5 Configuring the system 101
Table 9 displays the command syntax for configuring OSPF.
Table 9 Configuring OSPF over a secondary address
Command description Command syntax
Enable OSPF on a secondary addressCES(config-if)# ip ospf <secondary address>
Disable OSPF on a secondary address CES(config-if)# no ip ospf <secondary
address>
Set the OSPF authentication key CES(config-if)# ip ospf authentication-key
<auth-key> <secondary address>
Reset the OSPF authentication key CES(config-if)# no ip ospf authentication-key
<secondary address>
Set the OSPF cost on a secondary
address CES(config-if)# ip ospf cost <1-65535>
<secondary address>
Reset the OSPF cost on a secondary
address
CES(config-if)# no ip ospf cost <secondary
address>
Set the OSPF dead interval on a
secondary address
CES(config-if)# ip ospf dead-interval <1 -65535>
<secondary address>
Reset the OSPF dead interval on a
secondary address
CES(config-if)# no ip ospf dead-interval
<secondary address>
Set the OSPF hello interval on a
secondary address
CES(config-if)# ip ospf hello-interval <1 -65535>
<secondary address>
Reset the OSPF hello interval on a
secondary address
CES(config-if)# no ip ospf hello-interval
<secondary address>
Set the OSPF retransmit interval on a
secondary address
CES(config-if)# ip ospf retransmit-interval
<1-3600> <secondary address>
Reset the OSPF retransmit interval on a
secondary address
CES(config-if)# no ip ospf retransmit-interval
<secondary address>
Set the OSPF transmit delay on a
secondary address
CES(config-if)# ip ospf transmit-delay <1 -3600>
<secondary address>
Reset the OSPF transmit delay on a
secondary address
CES(config-if)# no ip ospf transmit-delay
<secondary address>
Set the OSPF network on a secondary
address to be a point-to-point or a
broadcast network CES(config-if)# ip ospf network <broadcast/
point-to-point> <secondary address>
Disable OSPF network on a secondary
address
CES(config-if)# no ip ospf network <secondary
address>
Set the OSPF polling interval on a
secondary address
CES(config-if)# ip ospf poll-interval <1-65535>
<secondary address>
Reset the OSPF polling interval on a
secondary address
CES(config-if)# no ip ospf poll-interval
<secondary address>
Nortel VPN Router Configuration — Basic Features