Adding a control tunnel, Creating control tunnels – Panasonic 7 User Manual
Page 143
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapter 7 Configuring control tunnels 143
Enter a name and then select select the parent group whose attributes the new
group inherits; for example, /Base. The group name can be a maximum of 64
characters (spaces are permitted). The new group inherits the attributes (for
example, Access Hours) of its parent group, which are then used by the
branch office connection. Click OK. The Branch Office window returns.
You can also click Search All Groups to use a connection name or partial
connection name to locate and display all matching groups. You can then
configure the specific group or groups that you want.
Enter the name your want to search for in the Search Criteria window and
click Search. The Search All Groups Results window appears, listing any
groups that match all or part of the specified connection name.
You can select a Group and then use the Configure button to review or
modify the group’s attributes.
Adding a control tunnel
To add a Control Tunnel connection:
1
On the Profiles >Branch Office window, in the Connections section, click
on Add. The Add Connection window appears.
2
Enter the Connection name (up to 128 characters).
3
For Control Tunnel, select Enabled.
4
For Tunnel Type, select FFTP, IPSec, or LT2P.
5
For Connection Type, select Peer to Peer, Responder or Initiator.
6
Click OK. The page refreshes.
7
Click OK again. The Connection Configuration window appears. Continue
to step 2 in “Configuring a control tunnel connection” on page 144.
Nortel VPN Router Configuration — Basic Features
3