Enterprise environment – Panasonic 7 User Manual
Page 62
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
After the VPN services are provisioned, branch office networks are logically
connected to a central office network or to a NOC network. Branch office end
users can rerun BOQS multiple times to restore the initial VPN configuration or to
fix data errors.
BOQS supports two network topologies:
•
Enterprise topology where the network operations center is located within the
central office.
•
Service Provider topology where the network operations center is an
independent entity from the central office
Enterprise environment
Before you deploy the Nortel VPN Router 1010, 1050, or 1100 switches at the
local sites, you must configure routing and tunnels on the switch at the central
office.
For routing, you must do the following:
•
Enable global RIP service.
•
Enable RIP on private interface.
•
Disallow importing default routes in the group where responder tunnels are
created.
62 Chapter 3 Setting up the Nortel VPN Router 1010, 1050, and 1100
For tunnels, you must do the following:
•
Create one responder tunnel for each branch office Nortel VPN Router 1010/
1050/1100 device.
•
Set the Connection Type to Responder.
•
Be sure that the Control Tunnel option is NOT selected.
•
Determine the connection name for the tunnel. Nortel recommends that the
name be the same as the initiator ID, but it could be the same as the central
office tunnel name.
•
Set the state to Enabled.
•
Set the Local Filter to permit all.
•
Set IPSEC Authentication to Text Pre-Shared Key.
•
Set the Initiator ID to the same name as the central office tunnel name.
NN46110-500