Panasonic 7 - Manual (Page 97)

Chapter 5 Configuring the system 97
4 MAC Pause (Ethernet packet flow control) section enables the Nortel VPN
Router to automatically adjust and control the flow of incoming and/or
outgoing packets from any standard speed LAN device.
Check to enable MAC Pause (Frame-based flow control) on the selected
interface port.
When enabled, specify the appropriate Pause parameters to be set in the
hardware.
5 Specify a value for MAC Pause Ticks.
6 Select a value from the Free Receive FIFO Threshold list. The default is 0.
7 Select Enabled or Disabled for the 802.1Q VLAN setting. Enabling 802.1Q
VLAN requires that you set this option to Enabled and then click OK. This
takes you back to the System > LAN window.
8 Enter an identification number for a VLAN ID in the range 1 - 4094,
inclusive. This is the VLAN identifier for the interface VLAN. The default
value is 1.
9 Select Accept Untagged to accept Ingress inbound frames untagged or
Discard Untagged to drop them.
10 Select Tagged too tag Egress (outbound) frames. Untagged is default.
11 Click Configure Subinterfaces to configure and to view existing VLAN
subinterfaces on the selected interface.
12 Click Subinterface Statistics to view current statistical information about the
selected VLAN subinterface.
Multinetting
You configure multinetting on the LAN port using either the System > LAN
window or on the CLI. Multinetting requires a primary interface that must be
present before adding secondary addresses. However, in a configuration where
both primary and secondary addresses are defined, changing the primary address
is not possible.
All secondary addresses must be deleted before the primary address can be
changed.
Nortel VPN Router Configuration — Basic Features