Static ip instructions – Panasonic 7 User Manual
Page 71
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
6
Set the Administrative State option to Enabled.
7
From the Interface Filter list, choose permit all.
8
Click on OK.
9
Locate the provisioning worksheet sent by the company or provider that sent
you the VPN Router.
10 Enter the following URL in your browser window:
manage/qs.pyc.
11 Click on Manage Switch, and then type admin and setup as the user name
and password.
12 Follow the instructions on the window that appears.
Static IP instructions
If your ISP assigns static IP addresses to your PCs, connect the VPN Router to the
Internet and then start the quick-start tool as follows:
1
Contact the ISP for the address to use.
2
Open a Web browser and enter the following URL in the browser window:
.
3
Click on Manage Switch, and then type admin and setup as the user name
and password.
4
From the menu bar, choose System > LAN to display the LAN Interfaces
window and select Cancel Acquisition..
5
From the Select Protocol list, choose IP and click on Apply. The Add IP
Address window appears.
6
Select the Static option and type the IP address and subnet mask that the ISP
provided.
7
From the Interface Filter list, choose permit all.
8
Click OK.
9
From the menu bar, choose Routing > Static Routes.
10 Click on Add Public Route (located under the Default Routes list).
11 The Add Public Default Route window appears.
Chapter 3 Setting up the Nortel VPN Router 1010, 1050, and 1100 71
Nortel VPN Router Configuration — Basic Features