Panasonic WV-BS504 - Manual (Page 11)

• ATW (Auto Tracing White Balance)
In this mode, the color temperature is monitored continuously and thereby white balance is set
automatically. The color temperature range for the proper white balance is approximately 2,6O0-6,000K,
Proper white balance may not be obtained under the following conditions:
1. The color temperature is out of the 2,600-6,000K range.
2. When the scene contains mostly high color temperature (bluish) objects, such as a blue sky or sunset.
3. When the scene is dim.
In these cases, select the AWC mode.
• AWC (Automatic White Balance)
In this mode, accurate white balance is obtained within a color temperature range of approx. 2,300 -
10.000K.
Note:
See page 24 for the setting.
(8) Wide Dynamic Range (WIDE D-RANGE)
Wide Dynamic Range makes it easier to monitor the picture when the lighting conditions in the location
where the camera is installed are too dim or too bright. You can select wide dynamic range (WIDE D-
RANGE ON) or normal dynamic range (WIDE D-RANGE OFF).
Notes;
• Use of the Wide Dynamic Range mode might not be appropriate when the scene consists mostly of
dark objects as this may result in a picture with a significant amount of noise.
• See page 25 for the setting.
(9) Motion Detector (MOTION DET)
The Motion Detector detects the motion in the scene by monitoring changes in the brightness level. You
can select the level of sensitivity for motion on the SET UP menu.
When this camera is connected to a compatible intelligent CCVE system, the camera transmits an alarm
signal by multiplexing it with the video signal.
When the camera detects the motion in AUTO, it supplies the alarm signal to the external equipment and
stops at its position for the preset dwell time. You can select the dwell time as follows;
OFF 1/2/3/5/10/20/30/60 min.
Note:
See page 25 for the setting.
(10) Auto Focus (AF MODE)
You can select one of two AF modes as follows:
MANUAL: AF mode is activated by pressing the AF button of the controller.
AUTO: AF mode is activated automatically after a manual panning, tilting or zooming operation.
Notes:
• AUTO in AF MODE is disabled unless SENS UP is set to OFF. If SENS UP is not OFF, AF MODE is set
automatically to MANUAL.
• See page 26 for the setting.
(11) Special Menu (SPECIAL)
This menu allows you to adjust the following items: upside down, chroma level, aperture level and pedestal
, level. You can also reset your parameters to the values preset at the factory.
See page 27 for the setting.
Setting Procedures
The following setting procedures are described on the assumption that this model is used in combination with
the
WJ-SX550A matrix switcher and WV-CU550A system controller. If used with the WV-RM70 camera
controller, refer to "WV-RM70" on page 5 for operation.
- 9 -