Panasonic WV-BS504 - Manual (Page 26)

8. White Balance Setting (WHITE BAL)
(available only \A/ith WV-CS604A, WV-CSR604, or WV-CST604)
(1) Auto-Tracing White Balance Mode (ATW)
• Display SET UP on the monitor screen.
(Refer to Setup Menu Display on page 10 for details on displaying the
SET UP menu on the monitor screen.)
• Move the cursor to WHITE BAL and select ATW by using the joystick.
The \ft/hite balance of the camera is automatically set.
• For fine adjustment of the ATW, press the CAM (SET) key to display
the ATW fine adjustment menu on the monitor screen.
You can mask the areas in this menu.
• Move the cursor to MASK SET and press the CAM (SET) key.
Forty-eight mask areas appear on the monitor screen.
Refer to the Light Control Setting section on page 20 for details about
masking areas.
• After masking areas, press the MON (ESC) key. The previous settings
ATW appear on the monitor screen.
• Move the cursor to "R."
Use the joystick to obtain the optimum amount of red gain. The T’
cursor moves to the left or right,
• Move the cursor to "B,"
Use the joystick to obtain the optimum amount of blue gain. The "I”
cursor moves to the left or right.
• Move the cursor to "RET” by using the joystick and press the CAM
(SET) key to return to SET UP,
Camera setting menu
/--------------------------------
** SET UP **
CAMERA ID OFF •
ALC/HANUAl. ALC *
SHUTTER OFF
AGC ON
SENS UP OFF
SYNC INT
WHITE BAD ^ATWlîj
WIDE D-RANGE OFF
MOTION DET OFF
AF MODE MANUAL *
RET SPECIAL *
V____________________ /
ATW fine adjustment menu
(2) Automatic White Balance Control Mode (AWC)
• Display SET UP on the monitor screen.
(Refer to Setup Menu Display on page 10 for details on displaying the
SET UP menu on the monitor screen.)
• Move the cursor to WHITE BAL and select AWC ^ PUSH SW by
using the joystick.
• Press the CAM (SET) key to start the white balance set- up. "PUSH
SW” starts blinking to indicate that the white balance is being set,
• “PUSH SW” stops blinking when balance setting is completed,
• For fine adjustment of the AWC, move the cursor to select AWC and
press the CAM (SET) key to display the AWC fine adjustment menu on
the monitor screen.
You can mask the areas in this menu.
• Move the cursor to MASK SET and press the CAM (SET) key.
48 mask areas appear on the monitor screen.
Refer to the Light Control Setting section on page 20 for details about
masking areas.
Camera setting menu
— ---------------
\
** SET UP **
CAMERA ID OFF *
ALC/MANUAL ALC *
SHUTTER OFF
AGC OH
SENS UP OFF
SYNC INT
WHITE BAL 'AWC PUSH ISWJ
WIDE D-RANGE ON
MOTION DET OFF
AF MODE MANUAL *
RET SPECIAL *
\ ________________________
AWC fine adjustment menu
-24 -