Installation, Precaution, Disassemble the camera – Panasonic WV-BS504 User Manual
Page 31: Setting the switches, Notes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALLATION
Precaution:
The following installations should be made by
qualified service personnel or system installers.
Setting the camera switches (only for WV-CSR604)
• To reset the communication parameters to the
factory preset values, for example, when
operating multiple cameras in a daisy chain
connection, set the switches inside the camera
as shown in the table below.
1
.
Disassemble the camera
Confirm the power is turned off.
Remove the screw from inside the hole for the
fall prevention wire. Hold the diecast case
containing the camera and rotate it to the left
as shown below.
Note: Setting of switches while the power is on
may cause a malfunction. Make sure the
power is turned off before setting the
switches.
2. Setting the switches
Set the switches as follows:
Dtp Switches
Switch A: Full duplex (four lines)/Half duplex
(two lines) switch
Switch B: Termination ON/OFF switch
Switch C; Dip switches (become effective when
the power is turned on)
Initialization of soft
ware communication
parameters
DIPS
OFF Normal Setting
ON
Initial
Settings
Notes:
• Select OFF after resetting the parameters by
selecting ON,
• The factory settings is OFF.
Camera Unit No,
DIP 1 DIP 2
OFF
OFF
01 - 32
OFF
ON
33-64
ON
OFF
65-96
ON
ON
Inhibition
The factory settings for the dip switch 1 and 2 are
OFF both.
- 2 9 -