Panasonic WV-BS504 - Manual (Page 28)

Move the cursor to DISPLAY MODE,
Press the CAM (SET) key to see the present setting. The masks that
detect the brightness change start blinking.
Move the cursor to LEVEL by using the joystick.
Use the joystick to obtain the optimum detection level. The "I" cursor
moves to the left or right.
Note; Repeat the above procedures until you obtain the desired
adjustment.
Move the cursor to RECOVER TIME by using the joystick.
You can select the recover time for from the following values:
—\
L_ _>
p-OFF-
L 60MIN
1MIN-*2MIN-* 3MIN 5MIN
»-30MIN-^20MIN -^lOMIN —
Move the cursor to RET and press the CAM (SET) key to return to SET
UP,
Important Notice:
• The object of motion detection should meet the following conditions,
1) It should be larger than 1/48 of the size of the picture screen.
2) The contrast ratio (at max. detection level) between the object and the background picture on the
screen should be more than 5%.
3) The time it takes the object to move from one end of the screen to the other should be more than 0.1
seconds.
• Also under the following conditions, mask or adjust the detection level to prevent malfunction.
1) When leaves or curtains etc, are swayed by the wind.
2) When a noisy picture exists such as under low light condition.
3) When the object is subjected to illumination by lighting equipment that constantly turns on and off.
• The alarm signal will take about 0.2 second to reach the alarm terminal of the VCR, after the camera
detects the object.
Because the alarm signal is multiplexed on the video signal it may be mistakenly interpreted by other video
equipment as a time code signal. Therefore, when this camera is not used in a Panasonic Intelligent CCVE
System, select OFF to prevent the above from occurring.
11. Auto Focus Setting (AF MODE)
1, Move the cursor to AF MODE, and move the joystick to the left or
right to set auto focus operation mode.
MANUAL: The AF mode is activated by pressing the AF button of the
controller.
AUTO; AF mode is activated automatically after a manual panning,
tilting or zooming operation.
Note: AUTO in AF MODE is disabled unless SENS UP is set to OFF.
If SENS UP is not OFF, AF MODE is set automatically to
MANUAL.
Camera setting menu
/
------------------
♦ * SET UP * *
CAMERA ID OFF *
ALC/HANUAL ALC *
SHUTTER OFF
AGC ON
SENS UP OFF
SYNC INT
WHITE BAL ATW *
WIDE D-RANGE OFF
MOTION DET OFF
AF MODE ¡MANUAL
RET SPECIAL *
\
__________
-J
- 2 6 -