Mounting screws, Attaching the brackets – Cisco IAD2430 User Manual
Page 43
3-7
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
OL-4234-06
Chapter 3 Installing Cisco IAD2430 Series IADs
Rack-Mounting the Chassis
Mounting Screws
Two sets of mounting screws are provided, in separate packages (Mounting screws are not included with
the Cisco IAD2435 IAD chassis). Take care to use each screw type, and washers as needed, in the
appropriate locations.
clarifies the differences between rack-mounting and wall-mounting
screws.
Attaching the Brackets
To install the chassis in a rack with the front panel forward, attach the brackets as shown in
.
Figure 3-4
19-Inch Rack Installation—Front Panel Forward
To install the chassis in a rack with the back panel forward, attach the brackets as shown in
Figure 3-5
19-Inch Rack Installation—Back Panel Forward
To install the chassis in a center-mount telco rack, attach the brackets as shown in
.
Table 3-1
Rack-Mounting Screws Versus Wall-Mounting Screws
Rack Mounting
Wall Mounting
•
Eight countersunk Phillips head screws (four
per bracket).
•
Four 6–32 slotted hex screws (two per
bracket) and four plastic washers.
•
Washers are not required.
•
Washers are required.
88840
CISCO IAD
2400
88841