Cisco IAD2430 - Manual (Page 44)

3-8
Cisco IAD2430 Series Integrated Access Devices Hardware Installation Guide
OL-4234-06
Chapter 3 Installing Cisco IAD2430 Series IADs
Rack-Mounting the Chassis
Figure 3-6 Telco 19-Inch Rack Installation—Back Panel Forward
To install the Cisco IAD2435 chassis in a rack with the back panel forward, attach the brackets as shown
in
Figure 3-7 .
Figure 3-7 IAD2435 Rack Installation with Back Panel Forward
Installing the Cisco IAD2430 Series IADs in a Rack
The following warning applies only when the unit is rack-mounted:
Warning To prevent bodily injury when mounting or servicing this unit in a rack, you must take special
precautions to ensure that the system remains stable. The following guidelines are provided to ensure
your safety:
This unit should be mounted at the bottom of the rack if it is the only unit in the rack.
When mounting this unit in a partially filled rack, load the rack from the bottom to the top with the heaviest component
at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting or servicing the unit in the rack.
Statement 1006
Warning Take care when connecting units to the supply circuit so that wiring is not overloaded. Statement 1018
To rack-mount the chassis, follow these steps:
Step 1 Choose one of the methods shown in Figure 3-4 on page 3-7 , Figure 3-5 on page 3-7 , Figure 3-6 on
page 3-8 , or Figure 3-7 on page 3-8 , and attach the long side of the mounting brackets to the chassis, as
shown.
88842
231983
IAD2435-8FXS
12V DC S A
CONSOLE
AUX
FastEthernet
WAN
0/1 0/0
T1/E1
FXS