KEYENCE PS-N10 Series - Manual (Page 4)

4
Mounting the Sensor Head
„ PS-45
Use the supplied fixing brackets. There are two ways to mount the sensor head. Make sure the
tightening torque does not exceed 0.6 Nm.
„ PS-46/52(C)/56
Use the supplied screws or other similar screws. Make sure the tightening torque does not
exceed the following values:
PS-46/56: 0.3 Nm or less
PS-52: 0.15 Nm or less
„ PS-47(C)/49(C)/55(C)
Install the M3 screws. Make sure the tightening torque does not exceed 0.6 Nm.
„ PS-48/58
Install the M3 screws when using the supplied fixing brackets.
Make sure to observe the following requirements when using setscrews to mount the sensor
head:
„
PS-05
When installing the holder, use the supplied screws and spring washers or other similar parts, as
shown on the right. Make sure the tightening torque does not exceed 0.5 Nm.
When fixing the PS-05 to the holder, use the supplied screw, nuts, spring washer, and flat
washer or other similar parts, as shown on the right. Make sure the tightening torque does not
exceed 0.5 Nm.
„
PS-201(C)/202
Use the supplied fixing bracket or similar bracket. Install the M3 screws.
„ PS-205/206
Install the M4 screws. Make sure the tightening torque does not exceed 0.5 Nm.
Model L Tightening torque
PS-48 5 mm or longer
0.15 Nm or less
PS-58 7 mm or longer
Note If you place the reflective PS-48 in the mounting hole, it is
affected by the light reflected from inside the hole. Place the front side
of the PS-48 so that it sticks out of the mounting hole, as shown above.
M3 setscrew (flat or dented head)
L
CAUTION
• Do not use setscrews to install the bracket.
• Do not bend the 20 mm cable that runs from the end of the sensor
head. Maintain a minimum bend radius of 25 mm.
Do not bend the 20 mm cable that runs from the end of the sensor
head. Maintain a minimum bend radius of 25 mm.
CAUTION
CAUTION