KEYENCE TM-3000 Series - Manual (Page 6)

6
Screen 1 Screen 2 Screen 3
ENTER
ESCAPE
MENU
PROG
NO. SCREEN
ZERO
TRG/
HOLD
IV -
11
Manual P5-10
Set the target within the measurement area and register the target as a master.
The registered image is called as a master image. The master image is used as a measurement standard.
Slide the [PROG/RUN] switch on the side of the console to display
the settings screen (screen 1).
Select “Master reg” on the setting screen (screen 1).
Press the [ENTER] key on the console to select the item.
On screen 2, press the [TRG/HOLD] key (console
illustration) on the console.
The measured image can be obtained on the screen.
Select the “Head A” button.
When “Master registration complete” window appears as shown
on screen 3, the master registration is complete.
Press the [ESCAPE] key to return to screen 1.
Following the setting flow, this section explains the settings and operation methods used for all measurements.
Master registration
XXX
Registering an image to be used as a measurement standard
Settings Used for All Measurements Settings Used for All Measurements
Sliding the side switch on the
console (PROG/RUN switch)
switches from the setting
screen to the measurement
screen and vice versa.
Console
[PROG/RUN]
switch
Setting procedure
IV
1
3
1
2
3
4
2