A&D Weighing SV-100 - Manual (Page 11)

9
3-2 Keys
Key Description
ON:OFF
Power
Turns the power on and off.
When the power is turned on, the viscometer enters the standby
mode ( [- - - - -] is displayed.)
START
Start
measurement
Start a measurement. (The processing indicator blinks.)
Displays the viscosity and temperature values in real time during
measurement.
STOP
Stop
measurement
Stops the measurement (The processing indicator is off) and freezes
the display of the viscosity and temperature values at the time the
STOP key is pressed during measurement.
When the STOP key is pressed again, the viscometer enters the
standby mode.
HOLD
Data hold
Freezes temporarily the display of the measurement data (viscosity
and temperature) at the time the HOLD key is pressed during
measurement. (The hold indicator is on.)
In the above condition, the measurement is continued. (The processing
indicator blinks.)
Pressing the HOLD key again releases the data hold mode.
∗1
MODE
Change units
Changes viscosity units. ∗1
(By the function setting "fnc 1", the measurement elapsed time can
be displayed.)
PRINT
Output data
Outputs the measurement data.
∗1 While the measurement is being performed using the graphing program RsVisco, the
data hold mode using the HOLD key and unit changes using the MODE key are not
available. RsVisco is contained in the accessory Windows communication tools,
WinCT-Viscosity.
While data are being output continuously (function setting "prt 2" or SIR command), the
data hold mode using the HOLD key is not available.