AERCO AM Series Boiler User Manual - Manual (Page 104)

AM Series Boilers and Water Heaters
CHAPTER 5 – OPERATION
Page 104 of 156 AERCO International, Inc. • 100 Oritani Dr. • Blauvelt, NY 10913 OMM-0100_0B
PRI - 07/14/14
Ph.: 800-526-0288
GF-146
5.2 General Operation – Water Heaters
This section applies only to the AM Series water heaters. For boilers, refer to section 5.1.
The heater is pre-set with standard parameters. However, it is possible to make a number of
changes or consult the parameters by means of using the User Menu (see Section 5.3) and the
Installer Menu (see Section 5.4).
During use, the “N” part of the display (in Figure 5-3) displays the storage tank temperature (if
boiler is performing heating) or the indirect water heater temperature. The M” part of the display
(in Figure 5-3) shows the pressure of the water system. The various operating statuses are
shown with other icons per Figure 5-3.
Figure 5-3: Water Heater Control Panel Functions and Indicators