Using the ice cube trays, On some models), Using the optional automatic ice maker – Whirlpool 3VED23DQDW00 User Manual
Page 17: Nmnnm, Doom
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using the ice cube trays
(on some models)
If cubes are not used, they may shrink.
The moving cold air starts a slow
evaporation. The longer you store
cubes, the smaller they get.
To remove ice:
1. Hold tray at both ends.
2. Twist slightly.
Doom
nmnnM
UP to
stop ice
maker.
DOWN to
start ice
maker.
Using the optional automatic ice maker
If your refrigerator has an automatic ice
maker, or if you plan to add one later
(contact the dealer for ice maker kit
number), here are a few things you
should know.
• The ON/OFF lever is a wire signal arm.
DOWN to make ice automatically
UP to shut off the ice maker
IMPORTANT: Do not turn ice maker
on until you connect it to the water
supply.
• If you remove the ice bin, raise the
signal arm to shut off the ice maker.
When you replace the bin, push it in all
the way and lower the ice maker signal
arm to the ON position.
• Good water quality is important for
good ice quality. Try to avoid connect
ing the ice maker to a softened water
supply. Water softener chemicals (such
as salt from a malfunctioning softener)
can damage the ice maker mold and
lead to poor ice quality. If you cannot
avoid a softened water supply, make
sure the water softener is operating
properly and is well maintained.
16