Removing the base grille, Using the thirstcrusher* dispensing system, On some models) – Whirlpool 3VED23DQDW00 User Manual

Page 18: The ice dispenser, Using the thirstcrusher, Dispensing system, Warning

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Removing the base grille

To remove the grille:

1. Open both doors.

2. Pull base grille forward to release the

support tabs from the metal clips.

3.

Do not remove Tech Sheet

fastened

behind the grille.

To replace the grille:

1. Line up grille support tabs with metal

clips.

2. Push firmly to snap into place.

3. Close the doors.

See cleaning instructions for defrost pan
and condenser coils on page 23.

Condenser

Using the THIRSTCRUSHER* dispensing

system

(on some models)

The ice dispenser

Ice dispenses from the ice maker

storage bin in the freezer. When the
dispenser bar is pressed, a trapdoor
opens in a chute between the dispenser
and the ice bin. Ice moves from the bin
and falls through the chute. When the
dispenser bar is released, a buzzing
sound may be heard for a few seconds
as the trapdoor closes. The dispenser
system will not operate when the freezer
door is open.

For crushed ice, cubes are crushed

before being dispensed. This may cause
a slight delay when dispensing crushed
ice. Noise from the ice crusher is normal,
and pieces of ice may vary in size.

When changing from CRUSHED to

CUBED, a few ounces of crushed ice will
be dispensed along with the first cubes.

To dispense Ice:

1. For cubed Ice,

move Ice Selector

Switch to CUBED position.

For crushed Ice

(on some

models), move Ice Selector
Switch to CRUSHED position.

^WARNING

Personal Injury Hazard

Tumbling ice and pressure on a
fragile glass can break it. Use a
sturdy glass when dispensing ice or
water.

Failure to do so could result in
personal injury or breakage.

сивев сйивмЕО

CUBED CRUSHED

œ

continued on next page

17

Advertising