Dimensions and clearance, Installation instructions – GE CGS990SETSS User Manual
Page 40
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation Instructions
DIMENSIONS AND CLEARANCE
Provide adequate clearances between the range and adjacent combustible surfaces. These dimensions must be met for
safe use of your range. The location of the electrical outlet and pipe opening (see Gas Pipe and Electric Outlet Locations)
may be adjusted to meet specific requirements.
The range may be placed with 0" clearance (flush) at the back wall. (Some models will not fit flush.)
For island installation, Model CGS990, maintain 2-1/2 in. minimum from cutout to back edge of countertop and 3 in.
minimum from cutout to side edges of countertop.
*Models PGB900,
PGB910, PGB915,
PGB930 and PGB935
require only 3"
minimum clearance
to left wall.
„ „„
18"
Minimum to
cabinets on
either side
of the range
i
‘ 30"
30"
Maximum
depth for
cabinets above
countertops
<-0"
To cabinets below cooktop
and at the range back
(Some models will not have
0" clearance.)
**Dimension are referenced from the point at
the back of the range that will contact the rear wall first.
Max dimension should be considered between the upper
and lower doors.
' Heightto backguard based on Café style backguard kit installed.
4 0