GE CGS975SEDSS - Manual (Page 41)

GEAppliances.com
AWARNING
Shock or Burn Hazard: Before replacing oven light bulb, disconnect the electrical power to the
range at the main fuse or circuit breaker panel. Failure to do so may result in electric shock or burn.
Oven Light Replacement (on some models)
Be sure to let the light cover and bulb cool
completely.
To remove the cover.
Twist lens counterclockwise about a
quarter turn to remove.
Do not remove any screws to remove the cover.
Replace bulb with a 40-watt appliance
bulb or two-prong halogen bulb, as
appropriate.
m
To replace the cover.
|~^ Line up tabs of lens in front of tabs on
housing and rotate clockwise to engage.
Oven Light Replacement (on some models)
ACAUTION
Before replacing
your oven light bulb, disconnect the electrical
power to the range at the main fuse or circuit
breaker panel. Be sure to let the light cover
and bulb cool completely.
The oven light bulb is covered with a remov­
able glass cover that is held in place with a
bail-shaped wire. Remove the oven door, if
desired, to reach cover easily.
To remove:
Hold a hand under the cover so it
doesn't fall when released. With fingers
of the same hand, firmly push back the
wire cover holder. Lift offthe cover.
Do not remove any screws to remove
the cover.
m
~2\ Do not touch hot bulb with a wet cloth.
Replace bulb with a 40-watt household
appliance bulb.
To replace cover:
iyi Place it into the groove of the light
receptacle. Pull the wire forward to the
center ofthe cover until it snaps into
place. When in place, the wire holds the
cover firmly. Be certain the wire is in the
depression in the center ofthe cover.
Connect electrical power to the range.
Removable Storage Drawer
(on some models)
|~^ Pull drawer straight out until it stops.
The storage drawer may be
removed for cleaning under the
range.
The storage drawer is a good place to store
cookware and bakeware. Do not store plastics
and flammable material in the drawer.
The storage drawer may be removed
for cleaning under the range. Clean the storage
drawer with a damp cloth or sponge. Never use
harsh abrasives or scouring pads.
To remove
storage drawer:
[2] Tilt the front of the drawer up and free of
the range.
To replace storage drawer:
|~^ Set the stops on the back of the drawer
over the stops in the range.
^ Slide drawer evenly and straight back, so
that the rails in the range are engaged.
41