Threading the upper looper, Threading the lower iooper -32 – Kenmore 385.166551 User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Threading the upper looper
Piace the spool of thread on the spool pin second from
the right.
Upper iooper threading points are marked in red.
A convenient threading chart is placed on the machine body
which is located inside the looper cover.
(T) Thread guide
(D
Thread guide plate
(D Upper looper thread tension dial
(4) Thread guide plate
(5) Looper thread guide
(D
Upper Looper thread take-up lever
(f) Upper iooper thread guide
(D
Upper looper
CC Draw the thread through the thread guide second from
the right from back to front.
® Thread guide
If the thread slips out from the thread guide groove while
serging, pass the thread through the thread guide hole as
shown.
I
Pass the thread through the second set of holes on the
thread guide plate as illustrated.
(2) Thread guide plate
Insert thread between the tension discs.
between the tension discs.)
(I)
Upper looper thread tension dial