Thread serging – Kenmore 385.166551 User Manual
Page 52
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
3-thread serging
Regular 3-thread serging: 1/8" (3.5 mm) width
• Use only right needle
Q] Turn off the power switch and unplug the machine.
[
2] Remove the needle and the thread on the left.
U] Then tighten the needle clamp screw on the left slightly
to avoid losing the screw.
Wide 3-thread serging: 1/4" (5.7 mm) width
• Use only ieft needle
D] Remove the needle and the thread on the right.
[2] Then tighten the needle clamp screw on the right slightly
to avoid losing the screw.
Advertising