Power failure process, Journal and receipt paper-end detector, Ecr printer motor lock detector – Toshiba TEC MA-1300 User Manual
Page 59
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
EOl-11064
9. POWER FAILURE PROCESS
If a power failure occurs, the sales memory is protected by the back-up battery; registration and
printing will normally be performed on regaining the power.
ECR CONDITION at the time of
POWER FAILURE
DISPLAY INDICATION on the POWER RECOVERY
OUTSIDE
A S A L E
No key-in has been
operated.
“0” display.
Numeric or Declaration
keys have been entered
but no motorized keys.
Same as above.
DURING
A S A L E
No Numeric or
Declaration keys have
been entered.
Regains the display content that was obtained just
before the power failure.
Numeric or Declaration
keys have been entered.
Same as above.
In the event of a power failure, it is suggested to check the receipt print content before the receipt is
handed to the customer.
10. JOURNAL AND RECEIPT PAPER-END DETECTOR
(1)
This detects when either the journal or receipt paper is running out. It is provided to
prompt the operator to replace the old paper roll with a new one.
(2)
When the paper roll is running out (or the paper has not been set properly), no key
operation is accepted and the AMOUNT portion of the display keeps flickering.
(3)
When a new paper roll is set, only the
[RF]
and
[JF]
keys are allowed to operate. Next,
when the
[C]
key is depressed, the display flickering will be cleared and normal key-in
operations will be accepted. When any printing has been suspended, it will continue
printing.
(4)
If this detector senses a paper-end condition during printing, the printing stops after the
current line printing is completed.
(5)
If the
[C]
key is depressed in the paper-end condition, it is ignored. The
[C]
key
depression will clear the display flickering only after the new paper roll is set.
NOTE:
This detector is not provided to a standard machine.
11. ECR PRINTER MOTOR LOCK DETECTOR
(1)
This detects the printer motor lock condition caused by some trouble, such as paper
jumming.
(2)
When such a condition is detected, the front display indicates “Error” and none of the keys
(including
{RF]
and
[JF]
)will be accepted.
(3)
To regain the normal condition, turn the power of the ECR to OFF, remove the cause of the
motor lock, and then turn the power to ON again.
- 55 -